2003-04 Mach 1 Registry Owners Club

Quote:

Originally Posted by MACHZILLA

When i start my MACH up and its sitting there idioling a rattle noise comes from my shaker. I put 1 finger on it and it stops,i take it off and it starts. ANY clues to make it stop?

will this help?

• BODY—NOISE—HOOD SCOOP (SHAKER) RATTLE Article No.
NOISE 03-22-1
• ENGINE—NOISE—HOOD SCOOP (SHAKER)
RATTLE NOISE
• NOISE—HOOD SCOOP (SHAKER) RATTLE NOISE
FORD: 2003-2004 MUSTANG
NOTE ISSUE
USING A SCREWDRIVER TO HELP GUIDE THE Some 2003-2004 Mustang Mach 1 may exhibit a
EDGE OF THE ISOLATOR INTO THE HOLE MAY rattle type noise from the Hood Scoop (Shaker)
DAMAGE THE MATERIAL OF THE ISOLATOR. area. The noise may occur at any engine RPM
and/or during acceleration or deceleration.
5. Once the entire outer edge is within the hole,
push the isolator down into the hole. ACTION
To service, install revised Hood Scoop Isolators 6. Reinstall the Hood Scoop.
(four), part number (2L7Z-9P686-AA). Refer to the
7. Verify the condition is corrected. following Service Procedure.
SERVICE PROCEDURE PART NUMBER PART NAME
2L7Z-9P686-AA Isolator 1. Remove the Hood Scoop per the Workshop
Manual (Section 303-12).
OTHER APPLICABLE ARTICLES: NONE
2. Place the Hood Scoop upside down on the WARRANTY STATUS: Eligible Under Provisions Of
workbench. New Vehicle Limited
Warranty Coverage NOTE
OPERATION DESCRIPTION TIME
PLACE HOOD SCOOP ON A CLOTH TO
032201A Install Revised Hood 0.7 Hr. PREVENT SCRATCHING OR MARRING OF THE
Scoop Isolators (Includes FINISH.
Time To Remove And
Install Hood Scoop) 3. Remove the four (4) isolators by grasping with
your fingers and pulling up and towards the
center of the isolator (Figure 1).
4. Install new Isolators (2L7Z-9P686-AA) by
setting the isolator in the hole at an angle
(Figure 2) and pressing down, while working
the outer edge of the isolator down into the
hole with your fingers.
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do
the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper
vehicle service. The procedures should not be performed by “do-it-yourselfers”. Do not assume that a condition described affects your car or truck. Contact a
Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle.
Copyright ã 2003 Ford Motor Company PAGE 1
Article No. 03-22-1 Cont’d.
DEALER CODING
CONDITION
BASIC PART NO. CODE
6N079 07
Figure 1 - Article 03-22-1
Figure 2 - Article 03-22-1
PAGE 2