Forum: General Registry Discussion
07-27-2019, 02:30 PM
|
Replies: 15
Views: 1,212
Re: 2020 Corvette. What do you think?
Well the ad said at first the starting price would be $50,000. Car is not even in showroom yet and went to $ 60,000. Several dealers around here are putting a Dealer mark-up of up to $10,000.They...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
07-27-2019, 02:18 PM
|
Replies: 7
Views: 1,425
Re: TPS voltage won't go below ~190
This sounds like a bad ground in the wiring . Check engine and PCM wiring harness for proper grounding. Use wiring Diagram for Pinpoint check on PCM outlet plug to see if 1.0 volt is present
|
Forum: Accessories - Non Performance type add-ons
07-08-2019, 03:43 PM
|
Replies: 6
Views: 4,270
|
Forum: Detailing/Cleaning Tips
05-02-2019, 07:09 PM
|
Replies: 11
Views: 15,193
Re: Dealing with rock chips
My paint on the bumper was bad too. I took it to a real good paint shop here . They said the paint was not done correct from the factory . They did a perfect match that does not chip or crack for...
|
Forum: General Registry Discussion
04-22-2019, 04:04 PM
|
Replies: 16
Views: 1,586
Re: 2020 Hi-Po 4 cyl?
Don't worry Ford is saving the Mustang on Earth Day !
They announced that a new Electric Mustang is in the development stages... LOL. Saving the Earth has a problem that no one wants to discuss....
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-15-2019, 11:02 AM
|
Replies: 15
Views: 1,782
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-15-2019, 10:58 AM
|
Replies: 15
Views: 1,782
Re: Spark plugs and lack of power
If its a Bama tune that is most likely the problem. There has been a lot of talk of the race tune being fueled too aggressive for the street.
I run NGK TR6 plugs ..the fine wire plugs run too hot...
|
Forum: General Registry Discussion
03-14-2019, 09:02 PM
|
Replies: 42
Views: 3,588
Re: Ford get it together!
The spray bore in the 18/19 block is out of round. Combine this with direct injection and bad ring seal is washing the cylinders down with gasoline. Several 1,500 mile engines have cylinder scoring...
|
Forum: General Registry Discussion
09-09-2018, 12:12 AM
|
Replies: 4
Views: 913
Re: Making my 2016 5.0 GT Greater
The Steeda rails IRS braces and strut braces are all made of powder coated chrome molly steel and are1/2 the weight of others.
Interior ...carbon dash bezel accent
Exterior ...Drake gas door and...
|
Forum: General Registry Discussion
09-07-2018, 05:10 PM
|
Replies: 4
Views: 913
Making my 2016 5.0 GT Greater
I have added several things so far...
Ford Performace... hood struts and upper strut brace.
SLP... axle back exhaust
Steeda ...IRS cage braces ,jacking rails, lower sub frame connectors
|
Forum: Engine & Drivetrain (Including trans & rear axles)
02-07-2018, 08:22 PM
|
Replies: 8
Views: 1,781
|
Forum: General Registry Discussion
02-05-2018, 11:57 PM
|
Replies: 20
Views: 4,754
Re: Got a deal on a 2016 Prem GT
I bought a GT 350 intake kit and going to use the Roush cold air kit with the 105 mm Mass air( Stock is 85mm). The stock 80mm throttle body will be used since the larger 87 mm does not add any hp...
|
Forum: Fluid Systems (coolant, oil, fuel)
02-05-2018, 05:53 PM
|
Replies: 113
Views: 105,263
|
Forum: General Registry Discussion
02-05-2018, 05:26 PM
|
Replies: 11
Views: 2,057
Re: 5.0 vs just the facts please
Well ...all has not been good for the GM boys either.
I can remember when the 1st LS series were coming into the shop with cylinders 7 and 8 with no compression ,cracked rockers or rod knock. We...
|
Forum: General Registry Discussion
02-03-2018, 07:31 PM
|
Replies: 11
Views: 2,057
5.0 vs just the facts please
I got a s550 with a 5.0 the newest 2015 -17 is even better than the s197 2014 5.0 why ?
The intake has the charge motion plates for better low end power. The heads are a cast version of the Boss...
|
Forum: Fluid Systems (coolant, oil, fuel)
02-03-2018, 01:15 AM
|
Replies: 3
Views: 1,122
Re: SVT Focus Pump & Fuel Level
You can bend the float wire and change the level but if the sending unit has a bad spot it will not read right.
Use an ohm meter to check it .Then test the gauge in the dash by grounding it. If it...
|
Forum: General Registry Discussion
02-02-2018, 01:46 PM
|
Replies: 16
Views: 2,169
|
Forum: Power Adders
02-02-2018, 12:16 PM
|
Replies: 10
Views: 2,138
|
Forum: General Registry Discussion
02-02-2018, 12:09 PM
|
Replies: 16
Views: 2,169
Re: Price for 03 stock Mach1 with under 4k?
Make sure you get a car fax done... a lot of low mile cars are damaged or flooded.
The Bullitt is going to a high priced, wiz bang GT with a GT 350 intake and tune making 475 hp. The GT 350 is now...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
02-02-2018, 11:59 AM
|
Replies: 21
Views: 3,212
Re: More issues 2.0
Before you change the MAF sensor try cleaning it with a special cleaner for them . This will either confirm or deny your MAF.
The main way water gets into the engine is the shaker to hood seal....
|