2003-04 Mach 1 Registry Owners Club

		2003-04 Mach 1 Registry Owners Club > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.02 seconds. Search: Posts Made By: TheWaterSkier

Forum: Engine & Drivetrain (Including trans & rear axles)

06-24-2004, 04:54 PM

Replies: 296

Sticky: Hanging/Slow dropping RPM FIX inside.

Views: 234,001

Posted By TheWaterSkier

Yes, that sounds like what happens. There is not...

Yes, that sounds like what happens. There is not much public information that I could find, but I did find this (http://afu.com/rolls/starter.html) . Scroll down the page to the section "A Modern...

Forum: Engine & Drivetrain (Including trans & rear axles)

06-24-2004, 01:00 PM

Replies: 296

Sticky: Hanging/Slow dropping RPM FIX inside.

Views: 234,001

Posted By TheWaterSkier

Doubt it... typical cranking speed of modern V8...

Doubt it... typical cranking speed of modern V8 engines is around 150rpms....

Forum: Engine & Drivetrain (Including trans & rear axles)

06-18-2004, 04:39 PM

Replies: 296

Sticky: Hanging/Slow dropping RPM FIX inside.

Views: 234,001

Posted By TheWaterSkier

I agree completely, it just appears that everyone...

I agree completely, it just appears that everyone is just using the one gasket in this thread and that didn't seem like a good idea to me... However, maybe it seals up just fine.... Personally, I'd...

Forum: Engine & Drivetrain (Including trans & rear axles)

06-18-2004, 03:48 PM

Replies: 296

Sticky: Hanging/Slow dropping RPM FIX inside.

Views: 234,001

Posted By TheWaterSkier

My point is, when you had just the IAC, you had...

My point is, when you had just the IAC, you had metal face, gasket, metal face. Now, with the new part, you have metal face, metal face, gasket, metal face. How is it that the part seals?

Forum: Engine & Drivetrain (Including trans & rear axles)

06-18-2004, 01:12 PM

Replies: 296

Sticky: Hanging/Slow dropping RPM FIX inside.

Views: 234,001

Posted By TheWaterSkier

You're using the original gasket and now you've...

You're using the original gasket and now you've stacked a metal plate against the IAC... How does this seal? Shouldn't it require a 2nd gasket to seal properly?

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 01:26 PM.