Just a little heads up on the tranny pull. I just did it for the first time. 2 things. 1. Haynes manual does not tell you to pull the starter (they do on the clutch section, but not the tranny section)
2. Take the panel on the front of the transmission off. The manual doesn't mention this either.
Maybe you already knew this, but I sure found out the hard way!
Not the best picture, transmission of left, oil pan on right. The panel I'm talking about is above the block of wood. The starter is hanging down on the bottom right of the picture. Make sure to get all three bolts on the starter. One goes into the front of the transmission, the other two are facing the same way as the transmission mounting bolts. Sorry if this is TMI
