Quote:
|
Originally Posted by Screamn03
I hope I didn't miss it but what did you use for a spring compressor? What make and model? Any pics of it?
TIA,
-Mike-
|
http://www.aglobalmart.com/Mach/tools.jpg
There is a tool for 4v motors and a separate tool for 2v motors. I actually bought both tools. The 2V tool will only get to half the springs on a 4v motor, but was easier to use and sturdier than the 4v tool. The 4v tool should be OK, but I would buy both even if I did it again. I think I paid about $200 for both tools.
Part number for 4v tool is OTC 303-452 (same as T93P-6565-AR)
Part Number for 2v tool is OTC 303-567
OTC is manufacturer. Bought mine online by searching for OTC tool dealers.