|
|
General Registry Discussion Topics of Interest (Mach 1 Related or otherwise) for discussions that don't fit other forums. |
|
Thread Tools | Display Modes |
11-15-2006, 12:41 AM | #1 |
Shakin' up the Streets
Join Date: Sep 2003
Location: Bayonne,NJ
Posts: 1,023
|
Definition of acceleration
Definition of Acceleration!
One Top Fuel dragster 500 cubic inch Hemi engine makes more horsepower than the first 4 rows of stock cars at the Daytona 500. Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro methane per second; a fully loaded 747 consumes jet fuel at the same rate with 25% less energy being produced. A stock Dodge Hemi V8 engine cannot produce enough power to drive the dragster's supercharger. With 3,000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition. Cylinders run on the verge of hydraulic lock at full throttle. At the stoichiometric (stoichiometry: methodology and technology by which quantities of reactants and products in chemical reactions are determined) 1.7:1 air/fuel mixture for nitro methane, the flame front temperature measures 7,050 deg F. Nitro methane burns yellow. The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases. Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder. Spark plug electrodes are totally consumed during a pass. After halfway, the engine is dieseling from compression, plus the glow of exhaust valves at 1,400 degrees F. The engine can only be shut down by cutting the fuel flow. If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half. In order to exceed 300 mph in 4.5 seconds, dragsters must accelerate an average of over 4G's. In order to reach 200 mph (well before half-track), the launch acceleration approaches 8G's. Dragsters reach over 300 miles per hour before you have completed reading this sentence. Top Fuel engines turn approximately 540 revolutions from light to light! Including the burnout, the engine must only survive 900 revolutions under load. The redline is actually quite high at 9,500 rpm. Assuming all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs an estimated $1,000.00 per second. The current Top Fuel dragster elapsed time record is 4.441 seconds for the quarter mile (10/05/03, Tony Schumacher). The top speed record is 333.00 mph. (533 km/h) as measured over the last 66' of the run (09/28/03 Doug Kalitta). Putting all of this into perspective: You are driving the average $140,000 Lingenfelter "twin-turbo" powered Corvette Z06. Over a mile up the road, a Top Fuel dragster is staged and ready to launch down a quarter mile strip as you pass. You have the advantage of a flying start. You run the 'Vette hard up through the gears and blast across the starting line and pass the dragster at an honest 200 mph. The 'tree' goes green for both of you at that moment. The dragster launches and starts after you. You keep your foot down hard, but you hear an incredibly brutal whine that sears your eardrums and within 3 seconds, the dragster catches and passes you. He beats you to the finish line, a quarter mile away from where you just passed him. Think about it, from a standing start, the dragster had spotted you 200 mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1,320 foot long race course. ...and that my friend, is ACCELERATION!
__________________
www.myspace.com/dontsleepmotorsports http://www.cardomain.com/ride/618244 Don't Sleep Motorsports "The man who says it can't be done should not interrupt the man doing it." |
11-15-2006, 01:12 AM | #2 |
Safe & Sound Speed
Join Date: Mar 2004
Location: Palmdale, CA
Posts: 499
|
Re: Definition of acceleration
Beautiful write up. I cant imagine 8 G's of force thats gptta be insane pressure if youre not prepared for it.
__________________
Oxford White 5 Speed 03 Mach 1
JLT Ram Air Intake 18 x 9 FR500's |
11-15-2006, 01:28 AM | #3 |
Living The Dream
Join Date: Sep 2002
Location: IL
Posts: 2,112
|
Re: Definition of acceleration
Still not as powerful as a Mach with a few well chosen bolt-ons (and a good tune).
__________________
2008 GT500 Alloy W/ Silver JLT/EVO tune BMR LCAs |
11-15-2006, 01:41 AM | #4 |
wears sunglasses at night
Join Date: Jun 2006
Location: KY
Posts: 1,163
|
Re: Definition of acceleration
Wow! I knew they were powerful, but that blows my mind!!!
__________________
2003 Sonic Blue Cobra Current Mods: - Hypercoated FR500's (18x9,18x10) - BFG KDW2 (265/35/18, 295/35/18) - Saleen Rear Wing - Densecharger Cold-air Intake - Bassani X-Pipe w/ high-flow cats, Magnaflow Catback w/ Flowmaster Mufflers - 2.93 Pulley - 470/534 rwhp/tq |
11-15-2006, 07:15 AM | #5 |
Greg Fonger
Join Date: May 2004
Location: Ontario, Canada
Posts: 3,416
|
Re: Definition of acceleration
Read that before but thanks for posting. I like it!
|
11-15-2006, 08:18 AM | #6 |
Terrible Dyno Car!
Join Date: Aug 2003
Location: Epping, NH
Posts: 6,666
|
Re: Definition of acceleration
Did you notice they never mentioned how much RWHP a top fueler is actually making?? I dont believe there is a system that can actually measure it.. Its over 6000 HP nowadays right?? It can be calculated by weight & ET/MPH though pretty close.. :THUMBSUP:
__________________
2003 Mach1 4-Speed Stick Axles of Evil Racing Bolt-On's All the good ones :PIMP: running 11.17's N/A on the stock factory motor. Results Best 1/4 mile 11.174 (Slicks) 11.2's (Quick TP's) 12.072 (17" Street Stocker wheels & tires) Best MPH 119.22 Best 60' 1.474 (With ET Drags) 1.51 (Quick TP's) 1.8's (17" stockers) |
11-15-2006, 08:23 AM | #7 |
Terrible Dyno Car!
Join Date: Aug 2003
Location: Epping, NH
Posts: 6,666
|
Re: Definition of acceleration
Actually using the ET & MPH #'s above they should have been making over 7000 RWHP..
__________________
2003 Mach1 4-Speed Stick Axles of Evil Racing Bolt-On's All the good ones :PIMP: running 11.17's N/A on the stock factory motor. Results Best 1/4 mile 11.174 (Slicks) 11.2's (Quick TP's) 12.072 (17" Street Stocker wheels & tires) Best MPH 119.22 Best 60' 1.474 (With ET Drags) 1.51 (Quick TP's) 1.8's (17" stockers) |
11-15-2006, 09:39 AM | #8 |
Loud, fast and fun
Join Date: Apr 2004
Location: Owning Ricers at MIR
Posts: 7,864
|
Re: Definition of acceleration
Most are now estimating they make over 8000 RWHP. The HP/ET Calculator doesn't work perfectly for them because they do most of the acceleration within the first 330 feet. I've seen a more in depth write up on them. They cut sub 1 second 60 feet and are at nearly 100 MPH when they cross the 60' mark.
|
11-15-2006, 09:47 AM | #9 |
Registered User
Join Date: Oct 2004
Posts: 57
|
Re: Definition of acceleration
Erotic
__________________
2004 Comp Orange Mach 1 Best 60-ft: 1.66 (2007) Best E.T. to date: 12.67 @ 110 MPH (2007) |
11-15-2006, 10:42 AM | #10 |
wears sunglasses at night
Join Date: Jun 2006
Location: KY
Posts: 1,163
|
Re: Definition of acceleration
I think i remember reading somewhere it was around 8000HP :THUMBSUP:
__________________
2003 Sonic Blue Cobra Current Mods: - Hypercoated FR500's (18x9,18x10) - BFG KDW2 (265/35/18, 295/35/18) - Saleen Rear Wing - Densecharger Cold-air Intake - Bassani X-Pipe w/ high-flow cats, Magnaflow Catback w/ Flowmaster Mufflers - 2.93 Pulley - 470/534 rwhp/tq |
11-15-2006, 12:21 PM | #11 |
Undocumented Member
Join Date: Feb 2004
Location: Enterprise, AL
Posts: 15,828
|
Re: Definition of acceleration
Cool read. :THUMBSUP:
I think our cars stack up pretty well if we can make it a two way run. :ORANGE: The acceleration theme could be continued to discuss the process of MAKING the turn-off or the tragic potentials involved with hitting something at those velocities. Driving TF sure won't get you low insurance rates. Thank God most of the time all goes well. Amazing machines --- past and present.
__________________
_____________________________________________ 2003 Mach1 AB 5spd 2004 Mach1 TR 5spd (sold) 1933 Ford 3W Coupe (4.6 dohc Stack Injection) 2003 Cobra TR (sold) 2014 Mustang GT (Track Pack) in Black |
11-15-2006, 12:55 PM | #12 |
Braderunna
Join Date: May 2004
Location: hampton, va
Posts: 4,949
|
Re: Definition of acceleration
Hey man, could ya pm me the name and # of that tuner? lol
__________________
"Sparky"- 2003 Azure Blue w/MT and IUP Visit my garage on mach1mustang.org for details. |
11-15-2006, 01:11 PM | #13 |
My First Mach, Jan. 1969
Join Date: Jan 2005
Location: Tacoma, Washington
Posts: 13,070
|
Re: Definition of acceleration
I will road race a top fuel car any day and win. LOL
|
11-15-2006, 01:48 PM | #14 |
LS WHAT?
Join Date: Apr 2005
Location: Stoughton, MA
Posts: 685
|
Re: Definition of acceleration
So why are we even modding our cars?!?!?
__________________
03 Mach1 exhaust, intake, tune. 12.9@109 2.051 60' |
11-15-2006, 06:30 PM | #15 |
Registered User
Join Date: Jun 2004
Location: Cincinnati, OH
Posts: 311
|
Re: Definition of acceleration
Acceleration = rate of change of velocity
|
11-15-2006, 07:05 PM | #16 |
On Permanant Vacation
Join Date: Feb 2004
Location: McVeytown, PA
Posts: 5,013
|
Re: Definition of acceleration
Bah..they're only fast because of all the stickers on 'em
__________________
And then one day you find, 10 years have got behind you, no one told you when to run, you missed the starting gun.. 18 Shelby GT 350 04 Mach 1 (Sold 9/1/2018 ) 18 Ford Explorer XLT 17 Mustang GT/CS Convertible 16 Fusion SE AWD Ecoboost 10 Fusion SE V6 66 289 Mustang Hardtop Restomod |
11-20-2006, 10:38 PM | #17 |
Shakin' up the Streets
Join Date: Sep 2003
Location: Bayonne,NJ
Posts: 1,023
|
Re: Definition of acceleration
__________________
www.myspace.com/dontsleepmotorsports http://www.cardomain.com/ride/618244 Don't Sleep Motorsports "The man who says it can't be done should not interrupt the man doing it." |
11-21-2006, 08:06 AM | #18 |
Heppasketties
Join Date: Aug 2003
Location: Mercer County, NJ
Posts: 4,760
|
Re: Definition of acceleration
Cool reading, thanks for posting.
HP is a measure of how fast and object moves Torque is a measure of how far and object moves when you run into it....
__________________
M1R Member #1829 2011 Shelby GT-500 Grabber Blue W/SVT Performance Package Born on Friday, 6-25-2010 Purchased 8-19-2010 2003 Zinc Yellow Auto I/UP (Build #8280 of 9652) Born on Thursday, 7/17/03 Purchased 8-18-2003 first owner Sold 8-19-2010 bought GT500 Purchased again 3-3-2017 fifth owner Purchased for my wife to drive (but she knows I love the car) |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|