|
||
|
|
||
07-22-2008, 01:52 PM
|
#1 |
|
12.98 @ 105 best 1/4
 
Join Date: Aug 2007
Location: Hastings, Ne
Posts: 252
|
auto conversion questions
Does anbody know which trans mount is to be used on the 99-04 when converting to a c4? I have a 01 cobra that had the 3650. My old trans mount is about 2"s away from where it bolts on the subframe when bolted it to the tranny. Will the aod mount work? Also will the speed sencer from a 4r70w work on the c4? And finally, does anybody know what driveshaft yokes will work? I know it has to be 28 spline but, will a yoke from a t5 or any aod work? Does the stock driveshaft work? Any help is appriciated.
__________________
01 Cobra, Hanlon t-45, Spec clutch, 26" QTP's, 15" draglites, Solid axle, Strange adj rear shocks, lakewood 90/10 front, Eibach drag springs, 4.10 gears, UMI solid lift bars, UMI double adj upper control arms, BBK full length sub-frame conectors, Pypes catback, Bassani off road X, FRPP Alum driveshaft, self cut & ported lower intake, JLT tru cold air, 90mm maf, SCT X-Cal2, kennebell BAP, 39lb injectors, 96 cobra intake cams, 3/4" intake spacer, dyno tune, March udp's, old 302whp 301rwtq |
|
|
|
07-22-2008, 04:19 PM
|
#2 |
|
Roll Tide !
 Join Date: May 2004
Location: Richmond
Posts: 2,491
|
Re: auto conversion questions
PM 9sec03cobra, he did my swap.
__________________
"The democracy will cease to exist when you take away from those who are willing to work and give to those who would not. " - Thomas Jefferson |
|
|
|
|
07-25-2008, 10:42 PM
|
#3 | |
|
In the 9's for real!!
Join Date: May 2006
Location: Virginia Beach,VA
Posts: 418
|
Re: auto conversion questions
Quote:
__________________
Kelley Performance 2004 Mach 1 9.78 @ 138.9 |
|
|
|
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
<
Linear Mode
